In this video tutorial I’m going to show you how to apply a skim coat to your walls for fresh new look.ĭIY Skim Coating- In this video I’m gonna show you how to mix the skim coat and also all of the tools needed to for mixing an all purpose joint compound for skim coating. GA-214-10e points out a skim coat is essentially a film of joint compound and is not a readily measurable thickness. John-Cocoa-Titusville Good luck with your skim coating project! -Paul The skim coating process involves applying a thin coat of joint compound to a divot. Proudly servicing these areas on the Space Coast: Melbourne-Melbourne Beach-Palm Bay-Indialantic-Indian Harbour Beach-Vero Beach-Satellite Beach-Viera-Cocoa Beach-Rockledge-Merritt Island-Cape Canaveral-Suntree-Port St. Skim coating is a quick and simple solution for repairing damaged walls. Then a 3/4″ nap will work fine for the second skim coat of all purpose joint compound to the wall or ceiling or skim coating. Tip: If you’re trying to cover up a knockdown or skip trowel texture, be sure to use at least a 1″ to 1 1/4″ roller cover when applying the first skim coat. Surface shall be free of excess joint compound. If you really want to do the skim coat, but especially in a bathroom, you should have installed moisture resistant drywall as. Fastener heads and accessories shall be covered with one (1) coat of joint compound. I think this how to skim coat trick saved me several hours of work by not having to take the extra time to try and keep the mud thickness as consistent as possible which means less sanding and mudding. Joint compound applied over the body of the tape at the time of tape embedment shall be considered a separate coat of joint compound and shall satisfy the conditions of the level. Once you get a good consistency, you’re ready to paint it onto the wall. Use your mixer attachment on the power drill until it’s smooth and well combined. ![]() I eyeball (rather than measure) the mix, but it should resemble a thick cake batter consistency. ![]() In Conclusion: I highly recommend this skim coating with the paint roller trick to any contractors or even Do it Yourself’ers for covering up an ugly texture, looking for a smoother finish on their drywall or plaster walls and ceilings, or even after removing wallpaper! Ready to walk through the skim coating process First you’ll mix your joint compound with water. To see more of my videos that I post on a weekly basisĬomments from: Paul Peck- Owner at Peck Drywall and Painting
0 Comments
Leave a Reply. |